It took two days to copy while HDD is in bottom up position. Copied those using Roadkil's Unstoppable Copier. I copied all the needed files, except two that failed reading at 95% due to bad sectors. The drive was detected and showed in Windows. Holding in this position, I connected the data cable, opened the Device Manager and performed a Scan for HW changes. Surprisingly, the gravitational force made the trick with the heads! The HDD started spinning without clicking. WD hard drive makes a repeated clicking sound Issue: A Western Digital hard drive makes a repeated clicking noise. I thought of opening and inspecting the heads and platters (drive has no critical data on it), pulled the HDD out and while holding it bottom up connected it to the power. Could be heads calibration issue or a damaged Service Area that stores manufacture data required for HDD operation. My HDD never fell, nor got a physical damage. A guy from recovery services said, if it's spinning, 99.9% it's not the PCB. Removing the data cable as WD suggest didn't help. My oldest WD internal drive is 14 yo and all of a sudden it started clicking loudly and shutdown itself after 30sec. Notify them of the problem and the drive will be replaced. Just get onto the WD website and log into the my support section. So for anyone whom does have a backup (and anything important should be backed up) then this is the best way to fix the problem. WD replaced the drives within a few days of me notifying them of the problem as well. Anyway luckily both of effected drives where still under warranty when it happened and both where backed up onto other copies. If your drive doesn't show up in a computer, unfortunately you will have to take the drive to a professional, but it will be extremely expensive to retrieve your data. On a side note I sync the backups using a program called Cronosync which syncs all new and updated files automatically at the click of a button. Clicking sound means there is physical damage on the hard drive, and it is having difficulty reading the surface of the disk. In the past six months I've had this happen twice so I am thankful that I always keep backups of everything. This is a relatively narrow range which indicates that the WD My Passport 0740 1TB performs reasonably consistently under varying real world conditions. During the LED while the instructions below. I have been using WD drives since 2012 and I now have 24 drives in total. This short video should show how i fixed the beeping problem of my WD My Passport Ultra. If your drive doesnt show up in a computer, unfortunately you will have to take the drive to a professional, but it will be extremely expensive to retrieve your data.
#WD MY PASSPORT BEEPING AND CLICKING FULL#
When all three drives are full I send the third drive back to my home country of Australia in case something happens to my drives in Vietnam. Clicking sound means there is physical damage on the hard drive, and it is having difficulty reading the surface of the disk. I travel regularly for work so I keep three copies of every drive so that I can travel with two drives and leave one behind in case I get robbed while I am travelling. I have a lot of WD drives, I'm a Vietnam based photographer and I use them to store my work on.
0 kommentar(er)
